Intended use
The order picker truck is designed for narrow
aisle operation. It permits pallets to be entered
into and removed from storage, as well as or-
der picking from the rack compartments.
Observe the instructions in the paragraph
"safety".
The maximum load that can be lifted is speci-
fied on the loadbearing information plate (load
diagram) and must not be exceeded.
Use for other purposes is prohibited.
If this truck is to be used for work which is not
described in these instructions or does not ap-
pear in the guidelines for the specified and
proper use of industrial trucks, and if it has to
be converted and retrofitted for this purpose, it
is necessary to be aware that modifications to
the original construction can impair the driving
behaviour and stability of the truck and are
therefore not permitted without our agreement.
Add-on parts and modifications (e.g. the weld-
ing-on of parts or the creation of openings)
could weaken the supporting structure and are
therefore only permitted after acceptance by
our design department. Functional changes
through modifications to the electrical system
or the software also require our acceptance
and release.
Before any such work is done you should
therefore make contact with the branch office
or the specialist representative in your area.
Description of truck
Instructions on operation of the individual
functions are provided in the respective chap-
ters.
General information
The operator can put himself and the load
suspension device (swivel fork) into the most
suitable working height by raising the opera-
tor's cabin. The auxiliary lift can be used to
serve the highest rack level and to set a fa-
vourable deposit height when carrying out
Overview
3
Intended use
295231 804 2502 EN - 04/2020
To Next Page
Loading...
