Still MX-X - Driving

Driving
Braking, driving and steering
Releasing the brake
After entering the driver's cab, close the barri-
ers or cab doors. Pressing the foot switch (1)
once confirms your presence. If the drive
switch is also actuated when the foot switch is
actuated, the electromagnetic parking brake is
released.
NOTE
The foot switch must be pressed again after
each time the barriers or doors are opened
and closed. The ancillary movements can only
be used when the industrial truck is at a stand-
still and the foot switch is not actuated.
Braking
Releasing the foot switch while driving triggers
the electrical reverse current braking. The in-
dustrial truck is braked to a standstill. Then the
electromagnetic parking brake is activated.
Releasing the operating lever for driving or the
left-hand sensor surface while driving triggers
the electrical reverse current braking. The in-
dustrial truck is braked to a standstill.
There are functions that only work when the
industrial truck is at a standstill. Therefore, it
can be necessary to release the foot switch in
order to use these functions. The correspond-
ing pictogram appears on the display.

Operation
4
Driving
70 5231 804 2502 EN - 04/2020