Driving
The drive direction and the driving speed are
selected using the right-hand operating lever.
Move the operating lever in the direction of the
fork (2) until the required driving speed in the
fork direction has been reached.
Move the operating lever in the direction of the
lift mast (3) until the required driving speed in
the direction of the lift mast has been reached.
If the operating lever is switched from one
drive direction directly to the other, the indus-
trial truck is braked and accelerated in the op-
posite direction.
Speed
The controller limits the driving speed depend-
ing on the driving situation and any options in-
stalled. It is always possible to have the speed
restricted by the authorised service centre, but
not to increase it. The operator can continu-
ously control the speed within the permitted
range.
The authorised service centre can configure
the acceleration and braking characteristics.
Steering
The operator's left hand is used to actuate the
steering knob (4) and thus determines the
course the truck takes. The steering knob has
a mechanical detent in the straight-ahead po-
sition. From there, the steering knob can be
turned approx. 135° to the right and to the left.
The steering turntable rotates by 90°.
If the industrial truck is being directed by a
guidance function (MZF or IZF), the steering
knob must be in the straight-ahead position.
Operation
4
Driving
715231 804 2502 EN - 04/2020
To Next Page
Loading...
