Overhead guard switch
The overhead guard switch fitted on the over-
head guard can detect obstacles above the
overhead guard using its ultrasonic sensor. If
it detects an obstacle, further lifting and thus a
collision between the driver's cab and the ob-
stacle is prevented. It is not possible to over-
ride this function.
The ultrasonic sensor can be adjusted by the
authorised service centre.
NOTE
Only obstacles that are directly above the
overhead guard are detected. Obstacles in the
drive direction or to the side are not detected.
NOTE
The overhead guard switch is one of the oper-
ator's assistance systems. The operator is re-
sponsible for working safely with the industrial
truck.
Working spotlights
Working spotlights are used to illuminate the
workplace outside the driver's cab. This can
include the storage spaces in the racking on
the right and left as well as the area in front of
the driver's cab where picked goods are stor-
ed. This makes working with the very narrow
aisle truck more effective and increases occu-
pational safety. The setting of the headlights is
customised. The headlights are switched from
the operating panel.
CAUTION
Impairment of occupational safety
Defective working spotlights must be repaired imme-
diately, as they help to improve occupational safety.
Special equipment
7
Overhead guard switch
144 5231 804 2502 EN - 04/2020
To Next Page
Loading...
