guide wire for inductive guidance in the centre
of the aisle and with guide rails for mechanical
guidance. The induction guide extends ap-
prox. 5 m into the aisle. The trucks are also
equipped with the
End of aisle slow down and
stop (ZAG)
option.
Entering the aisle
The truck is driven along the guide wire out-
side of the racking, according to the
End of
aisle slow down and stop
information in the
chapter entitled
Inductive guidance (IZF)
.
This means that the truck is aligned precisely
so that it can be driven into the guide rails.
Electrical aisle detection only occurs when the
truck is completely within the guide rails. Once
aisle detection has been successful, inductive
guidance is automatically turned off.
NOTE
If the man/auto button is not switched to auto-
matic, the truck behaves like a mechanically
guided truck. Switching from "auto" to "man-
ual" within the aisle has no effect.
Exiting the aisle
Switching from mechanical guidance to induc-
tive guidance takes place automatically when
exiting the aisle. To leave the guide wire, in-
ductive guide must be deselected by pushing
the man/auto button.
Special equipment
7
Aisle entry assistant
1215231 804 2502 EN - 04/2020
To Next Page
Loading...
