– Enter the correct PIN code.
NOTE
●
Each time the industrial truck is switched on
using the operator panel button, the PIN
code must be entered again.
●
If the industrial truck cannot be switched on
using the PIN code, call the authorised
service centre.
Factory setting
The factory setting for this PIN code is
"11111".
PINcode change
Up to five different codes can be used. The
customer can select codes between 10000
and 99999 and these can then be program-
med into the controller by the authorised serv-
ice centre.
Switching off
– To switch off the industrial truck, push and
hold the operator panel button for approx.
2 seconds.
RFID chip, RFID card
If an industrial truck is equipped with this sys-
tem, a reading device for RFID chips or for
RFID cards will be located in the driver's cab
in the vicinity of the operating panel. RFID
chips and RFID cards are included in the
scope of delivery according to the order. How-
ever, the authorised service centre does not
program the system to the customer's specifi-
cations until it is on site. Assignment to differ-
ent operators is possible using the various
RFID chips or cards.
Factory setting
Standard chips and cards are supplied at the
factory.
Activating the system
– Switch on the controller by pressing the op-
erator panel button (see above).
An LED illuminates on the reading device.
Special equipment
7
Electronic access control
126 5231 804 2502 EN - 04/2020
To Next Page
Loading...
