Still MX-X - Page 149

Emergency abseiling
Removing the windscreen
– Remove two knurled nuts (4) on both sides
and remove the clamping plates.
– Detach the windscreen from the Velcro
strips and bring it inside the cab.
– Stow it at the rear of the cab.
– Remove the abseil system from the storage
bag as described in the "Abseiling" section.
Installing the rope redirection
– An additional snap hook is hooked into the
chest eyelet of the safety harness. Remove
this snap hook.
– A snap hook is installed at the factory at the
front edge of the overhead guard (5).
– Hook the rope of the abseil system into this
snap hook. This snap hook thus serves as a
redirecting point for the rope.
– Screw on the screw fastening of the snap
hook.
– Carry out the abseiling process as descri-
bed in the "Abseiling" section.
– Only leave the cab once the abseil system
is correctly attached.
Inserting the windscreen
– First place the windscreen in the guide at
the bottom, align it in the centre and press it
into the Velcro strips.
– Fit the clamping plates and hand-tighten the
knurled-head screws (4).

Special equipment
7
Wind deflector cab
1415231 804 2502 EN - 04/2020