Foot switch
One or two additional foot switches (5) force
the passenger to adopt a safe position. If the
passenger releases one of the foot switches
during travel, the truck will stop immediately.
Further equipment
Depending on the lift mast design and cab di-
mensions, protection against accidental con-
tact with the lift cylinder situated behind the
cab can be installed.
Protection against leaning out towards the
rack at the side may also be required. This
protection system can be installed on the bar-
rier and is moved with the barrier when it is
being opened.
Safety
The sensor system of the two-person cab is
monitored electronically. This prevents operat-
ing errors and means that any damage should
be detected.
Display 813
Cause
●
Incorrect switching sequence. When the
key switch was set to ride on mode, one of
the enabling switches had already been ac-
tuated (manipulation of a switch or switch
defect)
●
One of the foot switches was actuated for
longer than 5 seconds before the second
foot switch was actuated
●
One of the enabling switches in the hand-
holds was actuated for longer than 5 sec-
onds before another switch was actuated
Effect
●
Lifting and lowering of the main lift is disa-
bled. No enable possible
●
Lifting and lowering of the auxiliary lift is dis-
abled. No enable possible
●
Driving disabled. No enable possible
Remedy
Release all switches and actuate them in the
correct sequence.
Special equipment
7
Two-person cab
1575231 804 2502 EN - 04/2020
To Next Page
Loading...
