aisle detection recognises the location of truck
and re-enables the steering.
Changing the aisle
If the industrial truck needs to be driven out of
one aisle and into another, the following notes
must be observed:
– Drive the industrial truck completely out of
the aisle.
– Slowly drive out of the aisle and beware of
any people or other industrial trucks in the
transfer aisle.
– Once the industrial truck is outside the rail,
the steering is reactivated by the rail switch.
– The industrial truck can then be turned 90°
on the spot and driven to the target aisle.
Operation
4
Driving
755231 804 2502 EN - 04/2020
To Next Page
Loading...
