The information contained in this document is confidential, and only for the information of the intended recipient and may not be published or redistributed without the prior written consent of Summa NV.
Summa nv Tel +32 59 27 00 11 Fax +32 59 27 00 63 Email support@summa.com Website www.summa.com Page 3 of 76
4.7 Knife drops on media or cutting strip when machine is switched off..................... 23
4.8 Drive drum keeps spinning .................................................................................... 24
4.9 Random reloading media ....................................................................................... 24
4.10 Random reboot ................................................................................................... 25
4.11 Display too bright ............................................................................................... 25
4.12 White line in display............................................................................................ 26
4.13 Flashing display .................................................................................................. 26
4.14 Display reacts incorrectly ................................................................................... 27
4.15 Vacuum fan does not work ................................................................................. 28
4.16 OPOS sensor makes repeated up down movements .......................................... 29
4.17 OPOS sensor starts searching 1 cm above mark ................................................ 29
4.18 Cutting stops after first panel ............................................................................. 29
4.19 Roll-up does not work ......................................................................................... 30
4.20 Ticking sound ..................................................................................................... 32
5 Media transport issues .................................................................................. 34
5.1 Using sheet media ................................................................................................. 34
5.2 Using roll media ..................................................................................................... 34
6 Cutting issues ................................................................................................. 39
6.1 Knife dropped in toolshaft ..................................................................................... 39
6.2 Uneven cutting depth ............................................................................................ 39
6.3 Unable to change cutting pressure ...................................................................... 41
6.4 Machine cuts lines twice ....................................................................................... 41
6.5 Knife scratches media ........................................................................................... 42
6.6 Knife plows through media .................................................................................... 43
6.7 Ragged contours ................................................................................................... 43
6.8 Bad cutting quality ............................................................................................... 44
6.8.1 Drag Head issues ............................................................................................................... 45
6.9 Curves do not close .............................................................................................. 47
6.10 Horizontal shift (Y axis) ...................................................................................... 48
To Next Page
Loading...
