Summa S Class 2 - Introduction to Summa S Class 2 Troubleshooting; Troubleshooting Summa S Class 2 Error Messages; Summa S Class 2: Other Operational Messages; Summa S Class 2: Troubleshooting Wrong Behavior

The information contained in this document is confidential, and only for the information of the intended recipient and may not be published or redistributed without the prior written consent of Summa NV.
Summa nv Tel +32 59 27 00 11 Fax +32 59 27 00 63 Email support@summa.com Website www.summa.com Page 2 of 76
Table of Contents
1 Introduction ...................................................................................................... 6
2 Error Messages ................................................................................................. 6
2.1 Y-axis error! Overflow! ............................................................................................. 6
2.2 X-axis error! Overflow! ............................................................................................. 7
2.3 Up-Down encoder not working ................................................................................ 8
2.4 Cutter is unable to find the knife home position ................................................... 10
2.5 Turn power off! Pinch rollers are not found .......................................................... 11
2.6 The middle pinch roller is not set properly above a sleeve! ................................... 13
2.7 The left pinch roller is not set properly above a sleeve! ........................................ 13
2.8 Unable to lower OPOS! .......................................................................................... 14
2.9 This media probably cannot be sensed properly ................................................... 15
2.10 Unlocking OPOS Barcode failed! ......................................................................... 15
2.11 Unable to sense OPOS Barcode! ......................................................................... 16
2.12 Activation of the G-Performance Mode failed! ................................................... 17
2.13 Flash device not found! ...................................................................................... 17
2.14 No memory for DMPL-buffer! Reboot… ............................................................. 17
2.15 No memory for display-stack! Reboot… ............................................................. 18
3 Other messages.............................................................................................. 18
3.1 Digitize origin ......................................................................................................... 18
3.2 Digitize point .......................................................................................................... 18
4 Wrong behavior .............................................................................................. 18
4.1 Machine does not start .......................................................................................... 18
4.2 Media does not load ............................................................................................... 19
4.3 Media not detected ................................................................................................ 20
4.4 Media crashes in basket ........................................................................................ 21
4.5 Machine freezes ..................................................................................................... 22
4.6 Knife keeps spinning ............................................................................................. 22