The information contained in this document is confidential, and only for the information of the intended recipient and may not be published or redistributed without the prior written consent of Summa NV.
Summa nv Tel +32 59 27 00 11 Fax +32 59 27 00 63 Email support@summa.com Website www.summa.com Page 9 of 76
• Connector for the coil (J1) came loose.
• Flat cable interrupted causing the knife not going up and down: replace the flat cable.
• Flat cable not firmly seated in the connector. Check on main board (J22: HEAD1) and on cutter
head (J5).
To Next Page
Loading...
