100 Sun Fire V890 Server Owner’s Guide • May 2004
3. Connect the other end of the cable to the RJ-45 outlet to the appropriate network
device.
You should hear the connector tab click into place.
Consult your network administrator if you need more information about how to
connect to your network.
What Next
If you are installing your system, complete the installation procedure. Return to:
■ “How to Install the Sun Fire V890 Server” on page 24
If you are adding an additional network interface to the system, then you need to
configure that interface. See:
■ “How to Configure Additional Network Interfaces” on page 94
To Next Page
Loading...
Need help?
General
