178 Sun Fire V890 Server Owner’s Guide • September 2004
Safety Agency Compliance Statements
Read this section before beginning any procedure. The following text provides safety precautions to follow when
installing a Sun Microsystems product.
Safety Precautions
For your protection, observe the following safety precautions when setting up your equipment:
■ Follow all cautions and instructions marked on the equipment.
■ Ensure that the voltage and frequency of your power source match the voltage and frequency inscribed on the
equipment’s electrical rating label.
■ Never push objects of any kind through openings in the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short circuit that could cause fire, electric shock, or damage to
your equipment.
Symbols
The following symbols may appear in this book and/or on the product:
Depending on the type of power switch your device has, one of the following symbols may be used:
Caution – There is risk of personal injury and
equipment damage. Follow the instructions.
Caution – Hot surface. Avoid contact. Surfaces
are hot and may cause personal injury if
touched.
Caution – Hazardous voltages are present. To
reduce the risk of electric shock and danger to
personal health, follow the instructions.
On – Applies AC power to the system.
Off - Removes AC power from the system.
Standby – The On/Standby switch is in the
standby position.
To Next Page
Loading...
