Chapter 2 Setting Up the System 35
5. Attach the mouse cable to the system’s remaining USB port, or to a USB port on
the keyboard, if applicable.
What Next
You can now issue system commands and view system messages. Continue with
your installation or diagnostic procedure as needed.
How to Power On the System
Before You Begin
Do not use this power-on procedure if the operating system is already installed and
you have just added a new internal option or external storage device. To power on
the system after adding one of these options, see:
■ “How to Initiate a Reconfiguration Boot” on page 40
What to Do
Caution – Before you power on the system, make sure that the front and side doors
and all plastic outer panels are properly installed.
1. Turn on power to any peripherals and external storage devices.
2. Turn on power to the alphanumeric terminal or local graphics console, if present.
To Next Page
Loading...
Need help?
General
