162 Sun Fire V890 Server Owner’s Guide • September 2004
How to Remove a Tape Cartridge
Before You Begin
The information in this section applies to a DDS-3 tape drive. If you have a different
type of tape drive installed, see the specifications shipped with the drive for
information.
What to Do
1. Check that there is no drive activity.
The green activity LED should be unlit. A flashing LED indicates drive activity.
Caution – Do not eject the tape cartridge when the drive is active, or you may incur
data loss or equipment damage.
2. Push the Eject button and remove the tape cartridge.
What Next
To insert a tape cartridge into the drive, see:
■ “How to Insert a Tape Cartridge” on page 161
Activity LED
Attention LED
Eject button
To Next Page
Loading...
