POWER UNIT 6-25
5. Remove bolts 1, thermostat cover 2 and thermostat 3.
6. Remove six (6) bolts 1.
Remove four (4) bolts 2.
Remove crankcase 3 from cylinder block.
7. Remove all conrod cap bolts 1 and conrod caps 2.
NOTE:
For proper assembly, mark cylinder number on all conrod caps,
using quick dry paint.
8. Remove crankshaft 1.
9. Remove oil seals 2 from crankshaft.
10. Push piston (with conrod) out through the top of cylinder
bore.
NOTE:
• For proper assembly, mark cylinder number on all conrods
and pistons, using quick dry paint.
• To prevent damage to piston rings, decarbon top of cylinder
bore wall before removing piston.
1
2
1
2
To Next Page
Loading...
