MID UNIT 7-7
DRIVESHAFT HOUSING AND OIL PAN
REMOVAL
1. Remove power unit. (See page 6-2 to 6-6.)
2. Remove lower unit. (See page 8-2.)
3. Remove screw and bonding wire from driveshaft housing.
4. Remove screw and bonding wire from swivel bracket.
5. Remove the two lower mount cover bolts and remove
STBD/PORT lower mount cover 1.
6. Remove two bolts and driveshaft housing (with oil pan).
7. Remove the upper mount stoppers 2.
During the removing the upper mount bolts, the drive-
shaft housing must be firmly secured.
To Next Page
Loading...
