3-22 IGNITION AND ELECTRICAL
REMOVAL/INSTALLATION
REMOVAL
Battery & Condenser charge coil
• Remove flywheel (See page 3-9.)
• Remove the stator base and battery charge coil (See page
3-10.)
Rectifier & Regulator
• Remove the bolts securing stator base. (See page 3-10.)
• Lift stator base from cylinder block and lay it on port side as
shown figure.
• Remove the screws securing the rectifier & regulator 1.
• Disconnect lead wire connectors.
INSTALLATION
Installation is reverse order of removal with special attention to
the following steps.
• Battery & Condenser charge coil
• Install stator base and charge coil. (See page 3-12.)
• Wire routing
• Check wire routing. (See page 9-3 to 9-9.)
Before removing electrical parts:
• Disconnect battery cables from battery.
• Disconnect spark plug cap from all spark plugs.
To Next Page
