4-2 FUEL SYSTEM
PRECAUTION ON FUEL SYSTEM SERVICE
GENERAL PRECAUTION
FUEL LINE
REMOVAL/INSTALLATION
Pay special attention to the following steps when removing or
installing fuel hoses.
NOTE:
• Check fuel hose routing. (See page 9-11 and 9-12.)
• Check for fuel leakage.
Gasoline is extremely flammable and toxic. Always
observe the following precautions when working
around gasoline or servicing the fuel system.
• Disconnect battery cables except when battery
power is required for servicing / inspection.
• Keep the working area well ventilated and away from
open flame (such as gas heater) or sparks.
• Do not smoke or allow anyone else to smoke near
the working areas.
Post a “NO SMOKING” sign.
• Keep a fully charged CO
2 fire extinguisher and
readily available for use.
• Always use appropriate safety equipment and wear
safety glasses when working around pressurized
fuel system.
• To avoid potential fire hazards, do not allow fuel to
spill on hot engine parts or on operating electrical
components.
• Wipe up fuel spills immediately.
• Do not over bend (kink) or twist hoses when install-
ing.
• When installing hose clamps (clips), position tabs to
avoid contact with other parts.
• Be sure hoses do not contact rods, levers or other
components with engine either operating or at rest.
• Extreme care should be taken not to cut, abrade or
cause any other damage to hoses.
• Use care not to excessively compress hoses when
tightening clamps.
To Next Page
Loading...
