LOWER UNIT 8-17
WATER INLET HOUSING
1. Apply grease to the oil seal.
99000-25161: SUZUKI WATER RESISTANT GREASE
2. Install the gasket 1, water inlet tube 2 and water drain tube
3 to the water inlet housing.
3. Install the exhaust seal core 5 and seal rubber 6.
4. Install the water inlet housing assembly to the gearcase.
Place the water inlet tube 2 and drain tube 3 into position.
WATER PUMP
1. Place the dowel pins 1, under panel gasket 2 and under
panel 3 into position.
2. Insert the key 4 in the driveshaft and slide the impeller 5
onto driveshaft, ensuring that key and keyway are aligned.
3. Install the pump case 6 while rotating driveshaft clockwise
to flex the impeller vanes in correct direction.
4. Tighten the four pump case bolts 7 to the specified torque.
Pump case bolt: 18 N·m (1.8 kg-m, 13.0 lb-ft)
To Next Page
Loading...
