6-34
CHASSIS
• Install the bearings
to
the wishbone arm to the specified depth
by using the
special tool and a suitable spacer
CD.
nQ! 09924-84510:
Bearing
Installer
NOTE:
•
Position
of
the bearing is shown in the illustration.
•
When
installing the sealed bearing that is used at the upper
wishbone pivot, make sure that the stamped side
of
bearing
faces to the spacer (j).
• Apply SUZUKI SUPER GREASE
~
A
"
to the dust seals and
bearing.
,0
99000-25030: SUZUKI SUPER
GREASE
" A" (USA)
99000-25010: SUZUKI SUPER
GREASE
"A"
(Others)
• Install the bearing spacers
(i)
and dust seals @ into the upper
wishbone arm.
• Apply SUZUKI SUPER GREASE
~A~
to the dust seals, dust
covers and bearing.
,0
99000-25030: SUZUKI SUPER
GREASE
"A"
(USA)
99000-25010: SUZUKI SUPER
GREASE
"A"
(Others)
• Install the spacer @, dust seals @, dust covers @ and wash-
ers (j) into the lower wishbone arm.
NOTE:
Stamped
mark on the dust seal ®
must
face outside.
• Degrease the tapered portion
of
knuckle and also knuckle end
with
nonflammable cleaning solvent.
12 mm (0.47 in)
To Next Page
Loading...
