5-18 COOLING AND LUBRICATION SYSTEM
• Install the new mechanical seal using a suitable size socket
wrench.
NOTE:
On the new mechanical seal, the seealer
A has been applied.
• Install the new bearing using the special tool.
& 09913-70210: Bearing installer set
• Install the rubber seal
1 into the impeller.
• After wiping off the oily or greasy matter from the mechanical
seal ring, install it into the impeller.
NOTE:
The paint marked side
A of the mechanical seal ring faces the
impeller.
• Apply grease to the impeller shaft.
* 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the impeller shaft to the water pump body.
To Next Page
Loading...
