Suzuki LT-Z400 - Page 178

CHASSIS 6-31
• Remove the spacer
1.
Inspect the bushing and dust seal for wear or damage. If any
damages are found, replace the shock absorber with a new one.
• Apply SUZUKI SUPER GREASE “A” to the bushing and dust
seals before remounting.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
KNUCKLE
Inspect the knuckle for damage. If any damages are found,
replace the knuckle with a new one.
KNUCKLE END
Inspect the knuckle end boot for wear or damage. If any dam-
ages are found, replace the knuckle end with a new one.
Inspect the knucle end for smooth movement. If there are any
abnormalities, replace the knuckle end with a new one.
• Remove the snap ring.
• Remove the knuckle end by using the special tools.
& 09913-70210: Bearing installer set