6-32 CHASSIS
WISHBONE ARM
Inspect the wishbone arm for wear or damage. If any damages
are found, replace the wishbone arm with a new one.
WISHBONE ARM PIVOT BEARING
• Remove the spacer and dust seal.
Inspect the dust seal lips and spacers for wear and damage. If
any damages are found, replace them with new ones.
NOTE:
Full type roller bearing is equiped at wishbone arm pivot. Take
notice that the rollers may fall out of bearing cage when remov-
ing the spacer.
Inspect the bearings for play. If excessive play is found, replace
them with a new one.
To Next Page
Loading...
