Suzuki LT-Z400 - Page 181

6-34 CHASSIS
• Install the bearings to the wishbone arm to the specified depth
by using the special tool and a suitable spacer
1.
& 09924-84510: Bearing installer
NOTE:
* Position of the bearing is shown in the illustration.
* When installing the sealed bearing that is used at the upper
wishbone pivot, make sure that the stamped side of bearing
faces to the spacer
1.
• Apply SUZUKI SUPER GREASE “A” to the dust seals and
bearing.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the bearing spacers
2 and dust seals 3 into the upper
wishbone arm.
• Apply SUZUKI SUPER GREASE “A” to the dust seals, dust
covers and bearing.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the spacer
4, dust seals 5, dust covers 6 and wash-
ers
7 into the lower wishbone arm.
NOTE:
Stamped mark on the dust seal
5 must face outside.
• Degrease the tapered portion of knuckle and also knuckle end
with nonflammable cleaning solvent.
12 mm (0.47 in)