CHASSIS 6-45
NOTE:
When installing the tie rod, make sure the narrow end
1 of the
tie rod comes out.
%
OIL TANK AND RADIATOR
• Install the oil tank. (!5-53)
• Reinstall the radiator assembly. (!5-6)
• Pour engine oil. (!2-12)
• Pour engine coolant and bleed air from the cooling circuit.
(!2-14)
HANDLEBARS
• Assemble the handlebars
1, handle holder
2 and steering
head cover bracket
3.
NOTE:
The higher portion of handlebar holder must face forward, so
that the clearance
A of holder is in back of the handlebars.
• Align the punch mark
B on the handlebars with the mating
surface of handlebar holder.
• First tighten the bolt
4 to the specified torque and then
tighten the bolt
5 to the specified torque.
# Handlebar clamp bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the steering head cover
6.
NOTE:
The indicator light position on the steering head cover is
described on page 7-22.
The locknuts
2 with a yellow finished surface have
left-hand threads.
Forward
Forward
To Next Page
Loading...
