Suzuki LT-Z400 - Page 193

6-46 CHASSIS
• Install the handle switch box with the lug
C on the switch half
inserted into the hole
D on the handlebars.
NOTE:
When installing the handlebars, make sure that the cable, wiring
harness and brake hose routing are proper. (!8-11 to 8-20)
• Install the clutch lever assembly to the handlebars with the
mating surface of clutch lever holder aligned with punch mark
E on the handlebars.
• Connect the clutch cable, rear brake cable and clutch switch.
• Adjust each cable play. (!2-16 and 2-17)
• Install the throttle case to the handlebars with the mating sur-
face of throttle case aligned with the punch mark
F.
• Tighten the throttle case bolts to the specified torque.
# Throttle case bolt: 5 N·m (0.5 kgf-m, 3.7 lb-ft)
• Install the brake master cylinder. (!6-27)
1 mm (0.04 in)