6-56 CHASSIS
• Apply SUZUKI SILICONE GREASE to the caliper holder slide
pin.
• Install the slide pin into the caliper.
+ 99000-25100: SUZUKI SILICONE GREASE
• Install the pin
3, washer
4 and caliper holder
5 to the cali-
per.
• Apply THREAD LOCK SUPER “1303” to the pin
3.
- 99000-32030: THREAD LOCK SUPER “1303”
• Tighten the pin
3 to the specified torque.
# Caliper holder slide pin: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the pad spring and pads. (!6-50)
NOTE:
When installing the slide pin
3 and washer
4, the convex of
washer must face slide pin as shown in illustration.
• Tighten the caliper mounting bolts
6 and brake hose union
bolt
7.
# Brake caliper mounting bolt:26 N·m (2.6 kgf-m, 19.0 lb-ft)
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
Before remounting the brake caliper, push the brake caliper pis-
ton all the way into the caliper.
%
• Install the parking brake housing
8 and new gasket.
• Apply THREAD LOCK SUPER “1360” to the parking brake
bolts and tighten them to the specified torque.
, 99000-32130: THREAD LOCK SUPER “1360”
# Parking brake bolt: 28 N·m (2.8 kgf-m, 20.5 lb-ft)
* The removed brake hose washers should be
replaced with new ones in order to prevent leakage
of brake fluid.
* Bleed air from the system after reassembling the
brake caliper. (!2-19)
To Next Page
Loading...
