Suzuki LT-Z400 - Page 204

CHASSIS 6-57
• When replacing the boot with a new one, apply SUZUKI SILI-
CONE GREASE to the groove of parking brake axle.
+ 99000-25100: SUZUKI SILICONE GREASE
• Loosen the locknut
a and turn the adjuster b in completely,
so that the cable play is maximum.
• Set the parking brake shaft
9 in neutral position by rotating
the shaft.
• Install the parking lever
0 onto the parking brake shaft 9
with the punch mark
A aligned with corner of hexagon on the
shaft
9, so that parking lever 0 is at angle of approx. 90
degrees to the line
B as shown in illustration.
• Hook the return spring
A on the parking lever with the spring
end faced the caliper as shown in illustration.
• Connect the parking cable
B.
• Install the adjuster
C and the locknut D.
• Adjust the parking brake. (!2-17)