6-86 CHASSIS
REAR AXLE SHAFT
When the rear axle shaft is replaced with a new one, install the
right axle nut onto the new axle shaft.
• Apply THREAD LOCK SUPER “1303” or “1322” to the axle
shaft.
- 99000-32030: THREAD LOCK SUPER “1303” (USA)
$ 99000-32110: THREAD LOCK SUPER “1322” (Others)
• Tighten the axle nut
1 to the specified torque.
# Rear axle nut (right) : 180 N·m (18.0 kgf-m, 130.0 lb-ft)
& 09940-92450: Rear axle nut holder
NOTE:
When tightening the axle nut with the special tool, the reading
torque on the torque wrench is smaller than actual torque that is
applied to the axle nut. Therefore convert the tightening torque.
(!6-88)
• Install the brake disc to the rear axle shaft.
• Apply THREAD LOCK SUPER “1360” to the disc bolts and
tighten them to the specified torque.
, 99000-32130: THREAD LOCK SUPER “1360”
# Disc bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
Make sure that the brake disc is clean and free of any grease
matter.
• Install the rear axle shaft into the axle shaft housing.
• Apply SUZUKI SUPER GREASE “A” to the spline of the axle
shaft.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
To Next Page
Loading...
