Suzuki LT-Z400 - Page 234

CHASSIS 6-87
• Install the sprocket flange
2 to the axle shaft.
• Apply SUZUKI BOND “1207B” or “1215” to the axle shaft.
/ 99104-31140: SUZUKI BOND “1207B” (USA)
0 99000-31110: SUZUKI BOND “1215” (Others)
• Apply THREAD LOCK SUPER “1303” or “1322” to the thread
portion of the rear axle shaft.
- 99000-32030: THREAD LOCK SUPER “1303” (USA)
$ 99000-32110: THREAD LOCK SUPER “1322” (Others)
• Install the concave washers
3 and tighten the inner axle shaft
nut inner
4 to the specified torque with the special tool.
# Axle shaft nut (inner): 180 N·m (18.0 kgf-m, 130.0 lb-ft)
& 09940-92450: Rear axle nut holder
NOTE:
When tightening the axle nut with the special tool, the reading
torque on the torque wrench is smaller than actual torque that is
applied to the axle nut. Therefore convert the tightening torque.
(!6-88)
• Apply THREAD LOCK SUPER “1303” or “1322” to the thread
portion of the rear axle shaft.
- 99000-32030: THREAD LOCK SUPER “1303” (USA)
$ 99000-32110: THREAD LOCK SUPER “1322” (Others)
• Tighten the rear axle outer nut
5 to the specified torque with
special tool.
# Axle shaft nut (outer): 180 N·m (18.0 kgf-m, 130.0 lb-ft)
& 09940-92450: Rear axle nut holder
NOTE:
When tightening the axle nut with the special tool, the reading
torque on the torque wrench is smaller than actual torque that is
applied to the axle nut. Therefore convert the tightening torque.
(!6-88)