6-88 CHASSIS
• Install the rear wheel hubs. (!6-14)
• Install the rear wheels. (! 6-14)
• Adjust the chain slack. (!2-22)
• Tighten the rear axle housing bolts to the specified torque in
the described order. (!2-23)
# Rear axle housing bolt (M10)
6:
73 N·m (7.3 kgf-m, 53.0 lb-ft)
# Rear axle housing bolt (M12)
7:
100 N·m (10.0 kgf-m, 72.5 lb-ft)
• Install the rear caliper and tighten the caliper mounting bolts
to the specified torque.
# Rear caliper mounting bolt: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
REAR AXLE NUT TIGHTENING TORQUE
Measure the effective length L of the torque wrench.
Calculate the reading torque on the torque wrench by use of the
formula shown below.
T: Reading torque on the torque wrench
Ts: Specified torque
Ls: 0.046 m (1.81 in)
Off-set of the specified special tool (09940-92450)
L: Effective length of the torque wrench
& 09940-92450: Rear axle nut holder
T=
L × Ts
L + Ls
Ls
L
To Next Page
Loading...
