ENGINE 3-13
• Hold the generator rotor using a 27-mm offset wrench.
• Loosen the clutch spring set bolts working in diagonal stages.
• Remove the bolts and springs.
• Remove the clutch pressure plate, clutch drive plates, and
clutch driven plates.
• Remove the clutch push piece
1, push rod
2.
• Flatten the clutch sleeve hub washer
3.
• Hold the clutch sleeve hub using the special tool, and then
remove the clutch sleeve hub nut.
& 09920-53740: Clutch sleeve hub holder
• Remove the clutch sleeve hub.
To Next Page
Loading...
