ENGINE 3-17
• Remove the neutral switch
1.
• Remove the O-ring
2, switch contacts
3 and springs
4.
• Remove the left crankcase securing bolts.
• Remove the right crankcase securing bolts.
• Separate the crankcase using the special tool.
& 09920-13120: Crankcase separating tool
NOTE:
Fit the crankcase separating tool to the right crankcase, so that
the tool plate is paralleled with the end face of the crankcase.
• Remove the dowel pin
5.
• Remove the gearshift fork shaft
6, reverse lock shaft
7,
gearshift forks
8 and gearshift cam
9.
To Next Page
Loading...
