Suzuki LT-Z400 - Page 60

3-16 ENGINE
• Remove the key
1, balancer drive gear 2 and pin.
• Hold the generator rotor using a 27-mm offset wrench, and
then remove the generator rotor nut.
• Remove the generator rotor using the special tool.
& 09930-31921: Rotor remover
NOTE:
Temporarily install the generator rotor nut to the crankshaft, and
then remove the generator rotor using the special tool.
"
• Remove the generator rotor key
3.
• Remove the starter driven gear
4.
Do not hit the generator rotor with a hammer, otherwise
the rotor may be damaged.