Suzuki LT-Z400 - Page 87

ENGINE 3-43
OIL PUMP IDLE GEAR SHAFT AND GEARSHIFT ARM
STOPPER
• Remove the oil pump idle gear shaft
1.
• Apply THREAD LOCK “1342” to the gearshift arm stopper.
• Tightening the gearshift arm stopper
2 to the specified
torque.
( 99000-32050: THREAD LOCK “1342”
# Gearshift arm stopper: 19 N·m (1.9 kgf-m, 13.5 lb-ft)
BEARING INSPECTION
Wash the bearing with a cleaning solvent and lubricate it with
motor oil before inspection. Rotate the inner race and check to
see that it turns smoothly. If it does not turn quietly and
smoothly, or if there are signs of any abnormalities, the bearing
is defective and must be replaced with a new one as follows.
BEARING REMOVAL
• Remove the bearing retainers.
• Remove the crankcase bearings using the special tool.
& 09921-20240: Bearing remover set
"
Play
Play
Replace the removed bearing with new ones.