TECO e510 series - Page 108

4-34
02- Motor parameters
02- 00 Motor No Load Current
Range
【0~【 (Patameter 02-01)-0.1】】
02- 01 Motor Rated Current
Range
【0.2~100】
02- 02 Motor Rated Slip Compensation
Range
【0.0 ~ 200.0】(%)
02- 03 Motor Rated Speed
Range
【0~39000】
When the load causes the actual motor speed to be reduced below the speed set by inverter output frequency
(Slip) , parameter 02-02 Slip compensation can be used to correct the speed.
Motor slip= Motor synchronization speed - Motor Rated Speed
Motor synchronization speed (Marked on the motor nameplate)
120
Motor Poles
Motor synchronization speed(RPM)= xMotor rate frequency(50/60Hz)
※
Note: 02- 00/02- 01 differs with the inverter capacities (13- 00),It should be regulated according to actual
conditions.
02- 04 Motor Rated Voltage
Range
【200V: 170.0~264.0 / 400V: 323.0~528.0】
02- 05 Motor Rated Power
Range
【0.1~37.0】
02- 06 Motor Rated Frequency
Range
【0~599.0】
02- 07 Motor Pole Number
Range
【2~ 16】
02- 14 Auto Tune
Range
【0】: Disable
【1】: Enable
02- 15 Stator Resistance Gain
Range
----
02- 16 Rotor Resistance Gain
Range
----