Page 43 of 957.10-00110b_en
Transport
5�8�3 Transport with a forklift
● To transport the mixer, this can be provided with two consoles, into which the forks of the
forklifts can be driven.
These must be mounted to transport the mixer.
● When lifting the machine, make sure that the centre of gravity of the machine is between
the forks of the forklift or pallet truck.
● The location of the centre of gravity must be determined by personnel instructed in techni-
cal safety during unloading and transporting work.
● If an unstable machine position is noted during lifting, put the machine down, approach it
with the forklift or pallet truck again, and lift again.
● Make sure that the machine is stable (no risk of tipping) and attach transportation locks if
necessary.
● Transport the machine to the place of installation carefully and slowly.
● At the place of installation, slowly and evenly place the machine onto its feet.
Do not jolt the machine onto the ground.
●
Fig. 32: Transport consoles
If the place of installation of the machine is in a space, niche, or free spot in the assembly
plant:
● Lower the machine onto the ground.
● Drive the forklift or pallet truck under the machine crosswise.
● Lift the machine.
● Transport the machine to the intended location.
● Lower the machine onto the ground.
To Next Page
Loading...