Page 71 of 957.10-00110b_en
Maintenance
10.1.7.3 Replacement of outer wall segments made from steel sheet or hard cast iron
1. Undo the screw connections on the outer wall of the mixer and remove the outer wall
segments.
2. Align the new outer wall segments on the outer wall of the mixer and screw them into place.
Make sure that there is no offset on the contact edges.
10.1.7.4 Replacement of wear parts of discharge slide seal
1. Unscrew the floor wear liner of the discharge slide.
2. Replace the parts and screw them back on.
1
2
Fig. 51: Replacement of wear parts of discharge slide seal
1 Discharge slide seal
2 Floor wear liner
To Next Page
Loading...