Teka THZ 375 - Oil And Filter Replacement; 10.2.2.1 Oil Replacement

Page 76 of 95
7.10-00110b_en
Maintenance
10�2�2 Oilandlterreplacement
I WARNING!
► Donotperformtheoilandlterreplacementwhilsttheoilis
hot�
► Donotushthetransmission.
► Donotmixdi󰀨erentoiltypes.
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
Fig. 57: Oilandlterreplacement
1 Ventilation lter
2 Rotor case
3 Oil dipstick
4 Oil line
5 Sealing cap
6 Gear pump
7 Filter housing with lter
8 Suction line
9 Oil drainage plug
10.2.2.1 Oil replacement:
1. Make sure that a su󰀩ciently large container is available to collect the oil.
2. Unscrew the sealing cap (5) at the bottom of the oil lling line (6).
3. Remove the oil dipstick (3) from the oil lling line (4).
4. Place the oil pan under the transmission.
5. Open the oil drainage plug (9) on the lower part of the transmission case.
6. Drain the oil.
7. Attach the sealing cap (5) again and close the oil drainage plug (9).
8. Add oil (see 10.2.2.3 "Adding oil").
9. Check the oil level, add more oil if necessary, and check the level again.
10. If the filling of oil is too slow, check the function of the venting nozzle (1) on the transmis-
sion case (see 7.5. "Opening the transmission ventilation").
Check the oil quantity with the oil dipstick and correct if necessary.