Analyzing waveforms Set up SPI search parameters
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown
above. These controls vary depending on the search Type. Setting the search conditions is similar to
setting the parameters for an Event Trigger
(see page 386).
NOTE. No info
rmation will be displayed in this window until you specify at least one search Type in
the Search Select Control Window (see page 300).
To use
Click the Source box and select the bus number or name from the window. Bus Search Selection
List (see page 98)
Select the type of bus cycle or a ctivity to search for from the Search For drop-down list.
For some Search For selections, you must set additional fields to define other parameters such as for
Data.
In this example, you n eed to set a Data Format, Number of Words, and Data Value (click the Edit
(see
page 939) button). O ptionally, you can also set the component threshold levels through the Logic
Thresholds Setup button.
Click the Search For selections Data (see page 325) or SS Active (see page 325), to view their parameters.
Wh
at do you want to do next?
Learn about bus setups. (see page 95)
324 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
