TESTO Saveris User Manual

7 Maintaining the product
134 0970 4020 en 01 testo AG
The fields of the
Channel name column for probe
designations are required fields. You must fill in these
fields to be able to continue with the startup.
The
Lower limit and Upper limit fields are already
preassigned limit values, but you can adapt the limit
values to your requirements.
The limit values determine as of which reading the
Saveris base triggers an alarm.
5. Click in the Channel name field and enter the designation
of the probe, e.g. "Room 4".
> Click in the
Lower limit field and change the lower limit
value.
If all probes are to have the same limit value, click on
the column title with the right mouse button and then
click on
Apply to all in the context menu. This also
applies for the upper limit value in the next step.
> Click in the Upper limit field and change the upper limit
value.
> Click in the
TC type field and enter the type of thermocouple
if this information is required for the instrument.
> Perform step 4 and the following for all other new probes
until all required fields are filled.
6. Click on
[Continue >].
- The settings for measuring cycle, the alarm delay and the
alarm issue are shown.

TESTO Saveris Specifications

General

Humidity Range	0 to 100 %RH
Measurement Parameters	Temperature, Humidity
Data Transmission	Wireless
Alarm Function	Yes
Resolution	0.1 °C, 0.1 %RH
Radio Frequency	868 MHz, 915 MHz
Data Storage	Internal memory, Cloud
Power Supply	Battery