8 Tips and assistance
158 0970 4020 en 01 testo AG
Meaning of the LED displays at the probes".
If you are outside of the range the LED lights up red. You
can then create or optimize the transmission path with a
router connected between the Saveris base and the probe.
Rough advanced planning using a floor plan of the building
has proved itself worthwhile.
7. The Saveris base shows an incorrect date and an
incorrect time. How can this be set?
You can synchronize the date and time when starting up the
hardware or within the Saveris software, meaning applying
the date and time from the operating system of the
computer; see "Starting up hardware" and "General settings
for the Saveris base".
The changeover between winter/summer time is made
automatically.
8. How long may the USB cable between the base and the
computer be?
The USB cable for connecting the Saveris base to the
computer may be a maximum of 5 m.
9. Why is a bidirectional radio used with testo Saveris?
Only by using a bidirectional radio (i.e. probes and Saveris
base are both transmitters and receivers) is it possible to
ensure that the data communication between the
participants can be performed without loss of data.
10. After the configuration of the probes and the base the
software was started, but no probes or readings are
shown.
For the initial start of the Saveris software after starting up
the system, it takes approx. 15 to 60 minutes until the first
readings from the system are entered in the database. The
probes and their readings are only visible in the software
when the data are present in the database.
11. The base was connected to a USB port of the computer
but is not automatically recognized by this.
Download the current USB driver for the Saveris system
from the Testo website (www.testo.com/saveris) and install
the new driver.
The Saveris base may not be connected to the computer
during the installation of the driver. After restarting the
To Next Page
Loading...
Need help?
General
