5 First steps
74 0970 4020 en 01 testo AG
5. Click on [Continue >].
- The settings for measuring cycle, the alarm delay and the
alarm issue are shown.
6. Enter the Measuring cycle and determine its Unit.
The measuring cycle determines in which intervals a
new reading is saved in the Saveris base.
Possible settings for the unit:
•
sec (second)
•
min (minute)
•
h (hour).
7. Determine Alarm delay.
If you enter the value "5" for example, an alarm is not
triggered by the Saveris base until the fifth time that the
limit value is exceeded.
To Next Page
Loading...
