265
33. CHANGING THE SETTINGS
[OFFSET] : Offset measurement
[TOPO] : To TOPO menu
[EDM] : Setting EDM
[H-SET] : Set required horizontal angle
[TILT] : Display tilt angle
[MENU] : To Menu mode (Coordinates measurement, setting-out
measurement, offset measurement, repetition measurement,
missing line measurement, REM measurement, resection
measurement, surface area measurement, set-out line, set-out
arc, point projection, intersections, traverse)
[REM] : REM measurement
[RESEC] : Resection measurement (The instrument station coordinate
can be recorded on the measurement result screen.)
[R/L] : Select horizontal angle right/left
[ZA / %] : Switch between zenith angle/slope in %
[HOLD] : Hold horizontal angle/release horizontal angle
[CALL] : Display final measurement data
[S-LEV] : Return signal
[AREA] : Surface area measurement
[F/M] : Switch between meters/feet
[HT] : Set the instrument station height and target height
[S-O LINE] : Setting-out line measurement
[S-O ARC] : Setting-out arc measurement
[P-PROJ] : Point projection measurement
[PTL] : PT to Line
[INTSCT] : Intersections measurement
[TRAV] : Traverse adjustment
[ROAD] : Route surveying
[X SECT] : Cross section survey
[TOPOII] : Topography observation
[L-PLUM] : Brightness configuration for laser plummet
[HVDOUT-T] / [HVDOUT-S]
: Output distance/angle measurement results to an external
instrument
[HVOUT-T] / [HVOUT-S]
: Output angle measurement results to an external instrument
[NEZOUT-T] / [NEZOUT-S]
: Output the coordinate results to an external instrument
[---] : No functions set
To Next Page
Loading...
