230
30. REGISTERING/DELETING DATA
It is possible to register or delete coordinate data of the known points in the
current JOB.
The coordinate data that has been registered can be output during setting for use
as instrument station, backsight station, known point, and setting-out point
coordinate data.
• It is possible to register 10000 items of coordinate data, including the data
inside the JOBs.
• There are two registration methods: key entry and entry from an external
instrument.
Communication cables: "36.2 Optional accessories"
Output format and command operations: "Communication manual"
• When entering known point data from an external device, ES does not check
the repeated point name.
• Communication setup can be performed in the known data as well. Select
“Comms Setup” in <Known data>.
• When “inch” is selected as the distance unit, the value must be input in “feet" or
"US feet".
• Deleting each data does not free the memory. When a JOB is deleted, the
occupied memory is freed.
"29.2 Deleting a JOB"
PROCEDURE Using the key entry method to register known
point coordinate data
1. Select “Known data” in Data
Mode.
• Current JOB name is displayed.
30.1 Registering/Deleting Known Point Data
To Next Page
Loading...
