Topcon ES-101 - Procedure Power OFF

37
9. POWER ON/OFF
• When “Resume” in “Instr. config” is set to “On”, the screen previous to power off
is displayed (except when missing line measurement was being performed).
"33.1 Configuration -Config Mode-"
PROCEDURE Power OFF
1. Long push {ON} button.

• When there is almost no battery power remaining, the symbol will be
displayed every 3 seconds. In this event, stop measurement, switch off the
power and charge the battery or replace with a fully charged battery.
• To save power, power to the ES is automatically cut off if it is not operated
for a fixed period of time. This time period can be set in "Power off" in
<Instr.config.>.
"33.1 Configuration -Config Mode-"