Topcon HiPer+ - Page 162

Index
HiPer+ Operator’s Manual
Index
R
Radio configuration 3-3
RAM file 5-14, 5-15, 5-17
Range E-1
Real-time kinematic 1-2
See also RTK 1-2
Receiver modes 5-10
See also EIM
See also Normal Mode
extended
5-12–5-13
sleep mode 5-10
zero power 5-11
Recording interval 3-28
Reset key 1-8
Rover 4-3
definition, RTK 3-14
definition, static 3-14
kinematic setup 4-11
RTK survey, LQ field 3-24
setup 4-3
Rover receiver, definition 3-1
RS232 connection parameters 3-16
RTK package contents 1-7
RTK survey, definition 3-14
RX LED
and red flashes 6-14
blink pattern 1-12
S
SAE-to-SAE extension cable 2-13
Scripts 3-5
Scripts, create B-1
Security parameters 2-19
Serial number 3-18
Set baud rate
115200
1-12, 2-15, 3-16, 5-14,
6-11
38400 3-4, 3-9, 3-10
SHMM 1-8, 1-13
Slant height measure mark
See SHMM
Sleep mode
5-10
Software 2-2
BTCONF 2-5
FLoader 2-6
PC-CDU 2-3, 3-15–3-24,
3-27–3-32
PDLCONF 2-4, 3-3, 3-5–3-9
radio configuration 3-3
STAT LED 1-10, 5-12
blink pattern 1-10, 5-12–5-13
EIM 5-12
green 1-10
orange 1-10
red 1-10
Static survey, definition 3-14, 4-10
Stop and Go survey 4-11
configuration 4-11
Stop and Go survey, definition 4-11
Surveying
static 4-10
stop and go 4-11
System range E-1
T
Test 1-6, D-3
EIM 5-12–5-13
U
UHF modem 1-7, 1-15
antenna 1-15
configuration 3-4–3-11
RX LED 1-12
UHF usage E-1
Unable to connect 2-16
Uninstall
BTCONF 2-5
FLoader 2-6
PC-CDU 2-3
USB connection parameters 3-16
USB driver 2-14, 3-14