- 102 -
5.2 Error Code in Communication
One of the following error messages is transmitted to the computer if an error occurs in the
instrument while measuring when it is connected to the computer.
Range over error
This code is returned when the brightness of the object exceeds the measuring
range of the instrument. Lower the brightness of the object, set a smaller measuring
field or insert the neutral density filter.
Measurement was stopped because the [MEAS./HOLD] switch was pressed on the
main unit or a measurement cancel command was received during remote
measurement.
The status of receiving the external sync. signal is abnormal. It is necessary to
check the sync. signal generator or BNC cable.
There is an internal error. Contact TOPCON TEHCNOHOUSE or your retailer.
To Next Page
Loading...
Need help?
General
